Make two separate polygon selections on the object, and then click Bridge.

To do this, select the Move transform tool and then hold Shift as you drag the polygon.Ĭonnects two polygons or polygon selections on an object with a polygon “bridge.” There are two ways to use Bridge in Direct Manipulation mode (that is, without opening the Bridge Settings dialog): Tip: You can also interactively inset polygons directly in the viewport. Click Extrude again or right-click in the active viewport to end the operation.

You can drag other polygons in turn to extrude them while the Extrude button is active.

With multiple polygons selected, dragging on any one extrudes all selected polygons equally.

Drag vertically to specify the extent of the extrusion, and horizontally to set the size of the base.

When over a selected polygon, the mouse cursor changes to an Extrude cursor.

Click this button, and then drag vertically on any polygon to extrude it.Įxtruding polygons moves them along a normal and creates new polygons that form the sides of the extrusion, connecting the selection to the object.įollowing are important aspects of polygon extrusion: Lets you perform manual extrusion via direct manipulation in the viewport. To stop inserting vertices, right-click in the viewport, or click Insert Vertex again to turn it off.

You can continue subdividing polygons as long as the command is active. Applies to polygons, even if at the element sub-object level.Īfter turning on Insert Vertex, click a polygon to add a vertex at that location.

Smart object is not directly editable